3750-sw01(config)#license boot level ipservices switch 1. 3750-sw01(config)#license boot level ipservices switch 2. When I do a "sh ver" I can see only switch 1 says "Next reload license Level: ipservices", not switch 2. Switch 2 specifies "Next reboot licensing Level : ipbase". When I session to switch 2, I can't go into config t mode to enter the above commands. I am not quite sure why ...
· Issue: To enable the “IPservices” license on the 3750X stack we are using the below commands. 3750-sw01(config)#license boot level ipservices switch 1. 3750-sw01(config)#license boot level ipservices switch 2. In switch 2, we can’t go into config t mode to enter the above commands and config t mode fails. 3750-sw01-2#conf t
I have a stack of 3750s and I'd like to upgrade from ipbase to ipservices. My IOS is universal type of IOS and I have the license for the ipservices.
· RE: Can I mix IPbase & IPservices IOS in a 3750 stack VinceWhirlwind (TechnicalUser) 18 Aug 09 21:34 Yes, I think you've just saved yourself $60,000 at the cost of an extremely tiny risk.
Solved: In preparation for the future, I've been upgrading our switches. Inline with modern network design, I want to prepare ourselves for layer 3 to the edge. On my 3750s and 3650s should I install the advipservices, ipservices or would ipbase
· # delete /f /r flash1:c3750-ipbase-mz.122.35-35.SE5 # delete /f /r flash2:c3750-ipbase-mz.122-35.SE5 # dir flash1: # dir flash2: In the above delete command, /f stands for force, and /r stands for recurssive. On a side note, you should be using some software to monitor your switch status. If you are not doing it install Nagios, and monitor your switches. 4. Copy the IOS image to Cisco Switch ...
Solved: Hi All, Just doing a quick sanity check on my decision before I purchase but have found some conflicting information that I do with help clarifying! I'm purchasing a 3750X-48 and need to run OSPF, can I do this with IP Base? The Cisco
May it be bought with ipbase but it is simply not activated? Below is the right-to-use output with index 3 ipbase permanent but not activated and index 4 only eval ipbase for 90 days. Can I simply activate ipbase and reload the new switch or do I have to buy and upgrade to ipbase? Switch#sh lic right-to-use det Index 1 License Name : ipservices
For the Catalyst 3750 and 3560 switches, Cisco IOS Software Release 12.2(25)SEA and earlier referred to the image that provides Layer 2+ (L2) features and basic Layer 3 routing as the Standard Multilayer Image (SMI). The image that provides full Layer 3 routing and advanced services was referred to as the EMI. The inter VLAN routing feature is supported on both IP base or SMI and IP services ...
We never miss the music till the sweet-voiced bird has flown.